Dedicated Micros SD Advanced Installation And Operation Manual

Contents

Dedicated Micros SD Advanced Installation And Operation Manual Manual pdf 87 page image

Dedicated Micros ©2009 SD AdvancedE MailThe unit can automatically transmit an e-mail to an SMTP Server under numerous conditions i.e. onstart up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmannedapplications where a Remote Video Response Centre (or Manager etc.) would be notified by e-mailif any of these conditions occur.Connection Profile It is possible for the e-mail to be transmitted via the Ethernetnetwork or dial up connection (PPP ‘Point to Point Protocol’).This setting presumes that a modem has been connected orconfigured and the unit is connected to a LAN or WAN andallocated a valid IP address.Mail Server Address This is the IP address or URL of the SMTP Server that the e-mailwill be sent to. The SMTP server will then forward this to theintended recipient.Recipient Email This is the e-mail address of the intended recipient.Recipient Display Name This is the addressee name that will be shown in the email namefield.Reply to Email This field must be configured if the recipient is to reply to an e-mail. The unit does not accept incoming e-mails therefore ensurethis is a valid e-mail address.Reply To Display Name This is the ‘reply to’ name that will be shown in the emailname field.Sender Email These optional fields indicate the source of the e-mail notification.If the fields are left blank the unit will use the system name tocreate a sender name.