Using the Module BayAbout the Module BayAbout the Device Security ScrewRemoving and Installing Devices While the Computer Is Turned OffRemoving and Installing Devices While the Computer Is RunningAbout the Module BayYou can install devices such as a floppy drive, CD drive, CD-RW drive, DVD drive, CD-RW/DVD drive, DVD+RW, second battery, or second hard drive in themodule bay.About the Device Security ScrewYour Dell™ computer may ship with a device security screw, which is not installed in the CD/DVD drive but packaged separately. When you install a module inthe bay, you can install the device security screw to prevent the module from being easily removed.Removing the Device Security ScrewIf a device security screw is installed on your computer, you must remove the screw to remove the module from the bay:1. Save and close any open files, exit any open programs, and shut down the computer.2. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.3. Close the display and turn the computer over.4. Use a #1 Phillips screwdriver to remove the device security screw from the bottom of the computer.Removing and Installing Devices While the Computer Is Turned Off1. If the device security screw is installed, remove it.2. Press the device latch release.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.NOTE: You do not need to install the device security screw (optional) unless you want to prevent the module from being easily removed.NOTE: If the device security screw is not installed, you can remove and install devices while the computer is running and connected to a docking device(docked).NOTICE: To prevent damage to devices, store them in a safe, dry place when they are not installed in the computer. Avoid pressing down on them orplacing heavy objects on top of them.