Dell Converged Enhanced Ethernet Administrator’s Guide xv53-1002116-01About This DocumentIn this chapter• How this document is organized . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xv• Supported hardware and software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvi• Document conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvi• Notice to the reader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xviii• Getting technical help . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xviiiHow this document is organizedThis document is organized to help you find the information that you want as quickly and easily aspossible.The document contains the following components:• Chapter 1, “Introducing FCoE,” provides an overview of Fibre Channel over Ethernet (FCoE) onthe Dell FCoE hardware.• Chapter 2, “Using the CEE CLI,” describes the Converged Enhanced Ethernet (CEE) CLI.• Chapter 3, “Initial FCoE and CEE Configuration,” describes some basic switch configurationsfor command SAN and LAN environments.• Chapter 4, “Configuring IP static routes,” describes how to configure IP static routes.• Chapter 5, “Configuring VLANs Using the CEE CLI,” describes how to configure VLANs.• Chapter 6, “Configuring STP, RSTP, and MSTP using the CEE CLI,” describes how to configurethe Spanning Tree Protocol (STP), Rapid STP (RSTP), and Multiple STP (MSTP).• Chapter 7, “Configuring Link Aggregation using the CEE CLI,” describes how to configure LinkAggregation and Link Aggregation Control Protocol (LACP).• Chapter 8, “Configuring LLDP using the CEE CLI,” describes how to configure the Link LayerDiscovery Protocol (LLDP) and the Data Center Bridging (DCB) Capability Exchange Protocol(DCBX).• Chapter 9, “Configuring ACLs using the CEE CLI,” describes how to configure Access ControlLists (ACLs).• Chapter 10, “Configuring QoS using the CEE CLI,” describes how to configure Quality of Service(QoS).• Chapter 11, “Configuring 802.1x Port Authentication,”describes how to configure the 802.1xPort Authentication protocol.• Chapter 12, “Configuring sFlow using the CEE CLI,”describes how to configure sFlow.
