822. Using a Network-Connected Machine (B1160w only)IPv6 configurationIPv6 is supported properly only in Windows Vista or higher.If the IPv6 network seems to not be working, set all the network setting tothe factory defaults and try again.In the IPv6 network environment, follow the next procedure to use the IPv6address.5From the Embedded Web ServiceYou need to access Embedded Web Service first using the IPv4 addressand follow the below procedure to use IPv6.1 Access a web browser, such as Internet Explorer, from Windows. Enterthe machine IP address (http://xxx.xxx.xxx.xxx) in the address field andpress the Enter key or click Go.2 If it’s your first time logging into Embedded Web Service you need tolog-in as an administrator. Type in the below default ID and password.• ID: admin• Password: dell000003 When the Embedded Web Service window opens, move the mousecursor over the Settings of the top menu bar and then click NetworkSettings.4 Click TCP/IPv6 on the left pane of the website.5 Check the IPv6 Protocol check box to activate IPv6.6 Check the Manual Address check box. Then, the Address/Prefix textbox is activated.7 Enter the rest of the address (e.g.,:3FFE:10:88:194::AAAA. “A” is thehexadecimal 0 through 9, A through F).8 Choose the DHCPv6 configuration.9 Click the Apply button.Using Embedded Web Service1 Start a web browser, such as Internet Explorer, that supports IPv6addressing as a URL.2 Select one of the IPv6 addresses (Link-local Address, StatelessAddress, Stateful Address, Manual Address) from NetworkConfiguration Report (see "Printing a network configuration report" onpage 77).3 Enter the IPv6 addresses (e.g.,: http://[FE80::215:99FF:FE66:7701]).Address must be enclosed in '[ ]' brackets.
