Use ToConfigure LogEnable AuditYesNoEnable Remote SyslogNoYesRemote Syslog Facility0–23Severity of events to log0–7Specify how and whether or not audit logs are created.Notes:• Enable Audit determines if events are recorded in the secure audit log andremote syslog. No is the factory default setting.• Enable Remote Syslog determines if logs are sent to a remote server. No is thefactory default setting.• Remote Syslog Facility determines the value used to send logs to the remotesyslog server. 4 is the factory default setting.• If the security audit log is activated, then the severity value of each event isrecorded. 4 is the factory default setting.Set Date and Time menuUse ToCurrent Date and Time View the current date and time settings for the printer.Note: The date and time are set in YYYY‑MM‑DD HH:MM format.Manually Set Date and Time[input date/time]Enter the date and time.Note: Setting the date and time using this menu automatically sets Enable NTP toOff.Time Zone[list of time zones]Select the time zone.Note: GMT is the factory default setting.Automatically observe DSTOnOffSet the printer to use the applicable daylight saving time (DST) start and end timesassociated with the printer Time Zone setting.Note: On is the factory default setting.Enable NTPOnOffEnable Network Time Protocol, which synchronizes the clocks of devices on anetwork.Notes:• On is the factory default setting.• Enable NTP is automatically set to Off if you manually set the date and time.Understanding the printer menus 71
