Setting the IP Address 55Verifying the IP SettingsYou can confirm the settings by using the operator panel, printing the printer settings report, or using the pingcommand.NOTE: A Password is required to enter Admin Menu when Panel Lock Set is set to Enable. In this case, enter thepassword you specified, and press the (Set) button.The Operator Panel1 Press the (Menu) button.2 Press the button until System appears, and then press the (set) button.3 Press the button until Admin Menu appears, and then press the (set) button.4 Press the button until Network appears, and then press the (set) button.5 Press the button until TCP/IP appears, and then press the (set) button.6 Press the button until IPv4 appears, and then press the (set) button.Check the IP address displayed on the operator panel.The System Settings Report1 Print the system settings report.For details about how to print a system settings report, see "Printing a Report/List Using the Operator Panel" onpage 175.2 Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under WiredNetwork or Wireless Network.If the IP address shows 0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for yourprinter, see "Assigning an IP Address" on page 53.The Ping CommandPing the printer and verify that it responds. For example, at a command prompt on a network computer, type pingfollowed by the new IP address (for example, 192.168.0.11):ping 192.168.0.11If the printer is active on the network, you will receive a reply.
