Dell DL1000 User Manual

Also see for DL1000: Owner's manual Deployment guide

Contents

Dell DL1000 User Manual Manual pdf 82 page image

Roadmap for performing replicationTo replicate data using AppAssure, you must configure the source and target cores for replication. Afteryou configure replication, you can then replicate data of the protected machine, monitor and managereplication, and perform recovery.Performing replication in AppAssure involves performing the following operations:• Configure self-managed replication. For more information on replicating to a self-managed targetcore, see Replicating To A Self-Managed Core.• Configure third-party replication. Fore more information on replicating to a third-party target core,see Replicating To A Core Managed By A Third Party• Replicate a new protected machine attached to the source core. For more information on replicatinga protected machine, see Replicating A New Protected Machine.• Replicate an existing protected machine. For more information on configuring an agent forreplication, see Replicating Agent Data On A Machine.• Set replication priority for an agent. For more information on prioritizing the replication of agents, seeSetting Replication Priority For An Agent .• Monitor replication as needed. For more information on monitoring replication, see MonitoringReplication.• Manage replication settings as needed. For more information on managing replication settings, seeManaging Replication Settings• Recover replicated data in the event of disaster or data loss. For more information on recoveringreplicated data, see Recovering Replicated DataReplicating to a self-managed coreA self-managed core is a core to which you have access, often because it is managed by your companyat an off-site location. Replication can be completed entirely on the source core, unless you choose toseed your data. Seeding requires that you consume the seed drive on the target core after you configurereplication on the source core.NOTE: This configuration applies to replication to an off-site location and to mutual replication. TheCore must be installed on all source and target machines. If you are configuring your system formulti-point to point replication, you must perform this task on all source cores and the one targetcore.Configuring the source core to replicate to a self-managed target coreTo configure the source core to replicate to a self-managed target core:1. In the Core, click the Replication tab.2. Click Add Target Core.The Replication wizard appears.3. Select I have my own Target Core, and then enter the information as described in the followingtable.Text Box DescriptionHost Name Enter the host name or IP address of the Core machine to which you arereplicating.82