36 Configuring the DR4000 System SettingsFILE LOCATION: C:\Users\bruce_wylie\Desktop\DellDocs\~Sidewinder_Docs_DR4000\FRAME_Conversion_DR4000_AdminGuide\~DR4000_AG_FD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 / 1 0 / 1 2 - F O R P R O O F O N LY14 To change current DNS Settings, click Edit DNS on the options bar.The Edit DNS dialog is displayed.15 Configure the following values in the Edit DNS dialog:• In Domain Suffix, type a domain suffix to use (for example,acme.local).• In Primary DNS, type an IP address that represents the primary serverfor your system.• For Secondary DNS, type an IP address that represents the secondaryserver for your system.16 Click Submit to configure the DNS settings for your system (or clickCancel to display the Networking page).The Updated DNS dialog is displayed when the selection is successful.Networking Page: Ethernet Port ValuesThe Networking page displays the currently configured multiple Ethernetports for the 1-GbE (or 10-GbE) NICs that are bonded together into a singleinterface:• In a 1-GbE NIC configuration, the two LAN on Motherboard (LOM)ports and the two ports on the NIC card itself are bonded together toconstitute the four ports.• In a 10-GbE NIC configuration, only the two ports on the 10-GbE arebonded together.The ports for the bonded NICs display the MAC address, the port speed inmegabtyes/second, a maximum speed, and the duplex setting.The following example shows Ethernet port values for the Ethernet ports in a1-GbE NIC bonded configuration:• Eth0:– MAC address: 00:30:59:9A:00:96– Speed (1000Mb/s)– Max Speed (1000baseT/Full)– Duplex (Full)• Eth1:
