Dell Dimension 9200C Service Manual

Also see for Dimension 9200C: Owner's manual Owner's manual

Contents

Removing and Installing Parts: Dell Dimension 9200C Service Manualfile:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]7. Replace the computer cover (see Replacing the Computer Cover).NOTICE: To connect a network cable, first plug the cable in to the network port or device, and then plug it in to thecomputer.8. Connect your computer and devices to electrical outlets, and then turn them on.See the documentation that came with the drive for instructions on installing any software required for drive operation.9. Enter System Setup (see Entering System Setup), and then select the appropriate Drive option.Media Card ReaderFor information about using the Media Card Reader, see your Owner's Manual.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in theProduct Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your bodybefore you touch any of your computer's electronic components. You can do so by touching an unpainted metal surfaceon the computer chassis.Removing a Media Card Reader1. Follow the procedures in Before You Begin.2. Remove the CD/DVD drive, if installed (see Removing a CD/DVD Drive).3. Remove the hard drive (see Removing a Hard Drive).4. Disconnect the interface cable from the back of the Media Card Reader and from the Media Card Reader connector onthe system board (see System Board Components).1 interface cable 2 Media Card Reader connector5. Pull up on the drive release latch and slide the Media Card Reader towards the back of the computer, then lift toremove the drive from the computer.