Removing and Installing Parts 73System Board ComponentsMemoryYou can increase your computer memory by installing memory modules on the system board. Forinformation on the type of memory supported by your computer, see "Memory" on page 105.NOTE: DDR 333 memory operates at 320-MHz when used with an 800-MHz front-side bus processor.secondary drive connector (SEC_IDE)floppy-drive connector (FDD)hard-drive connector (PRI_IDE) battery socket(BATTERY)SCSI_LED header (SCSI_LED)front-panel connector(FRONT_PANEL)standby power light(PWR_LED)rear fan connector(REAR_FAN1)memory moduleconnectors (1, 3)processor and heat-sink connector(CPU_PIN_#_A1)power connector(PWR)internal speaker (SPKR)power connector (12V_PWR)rear fan connector(REAR_FAN2)serial ATA connector(SATA_1)password jumper (PASS)PCI card connectors(PCI_SLOT_1, PCI_SLOT_2,PCI_SLOT_3, PCI_SLOT_4)AGP card connector(AGP)serial ATA connector(SATA_0)memory moduleconnectors (2, 4)front fan (FRONT_FAN)clear CMOS jumper(CMOS)T2310bk2.book Page 73 Thursday, February 5, 2004 10:00 AM
