Dell E600i Installation Manual

Also see for ExaScale E600i: Configuration guide

Contents

Power Supply | 23Power Cord RequirementsIf using a power cord other then a Dell Force10 supplied power cord, the cord must terminate at a rightangle (IEC320 C19 connector) to the power module, see Figure 6-3. The power source end of the powercord must have an appropriately sized plug that complies with your local electrical codes. Conductor sizemust also conform to your local electrical codes.The following are Dell Force10 supplied plug types.• EU: CEE 7/7• UK:CEE7/7, BS 1363• SWZ: CEE7/7, 309• JAP: NEMA 5-20• JAP 220: NEMA 6-20, L6-20• US: C14, C20, NEMA 5-20, L5-20• US 220: NEMA 6-20, L6-20, L6-30 (30A)Install the AC Power Supply UnitsTo install an AC power supply unit:Step Task1 Verify that the power switch on the power supply is in the OFF position.2 Orient the power supply handle to the left, and slide the backplane connector end into a power supply slot.3 Secure the power supply into place by tightening the two locking screws to 5 in-lbs.4 Plug an AC power cord into the socket on the front of the unit:a Loosen the power cord retainer thumb screw.b Rotate the retainer clockwise away from the socket and plug the power cord into the socket.c Rotate the retainer counter clockwise over the power cord, and tighten the thumb screw to secure the powercord.Figure 6-3. Securing the AC Power Cord5 Plug the AC power cord into an AC outlet.