Dell Edge Gateway 3003 Installation And Operation Manual

Also see for Edge Gateway 3001: Getting started guide Getting started guide Getting started guide Installation and operation manual

Contents

Dell Edge Gateway 3003 Installation And Operation Manual Manual pdf 12 page image

This product is designed for specific applications and needs to be installed by qualified personnel with RF and regulatory-relatedknowledge. The general user shall not attempt to install or change the setting.Installation locationThe product shall be installed at a location where the radiating antenna is kept 20 cm from nearby persons in its normal operationcondition in order to meet regulatory RF exposure requirements.External antennaUse only approved antenna(s). Non-approved antenna(s) may produce spurious or excessive RF transmitting power which may lead to aviolation of FCC/IC limits.Installation procedureRefer to user’s manual for installation instructions.WARNING: Carefully select the installation position and make sure that the final output power does not exceed the limits describedin the product’s documentation. The violation of these rules could lead to serious federal penalties.Instructions d'installation professionnellesLe personnel d'installationCe produit est conçu pour des applications spécifiques et doit être installé par un personnel qualifié avec RF et connaissances connexesréglementaire. L'utilisateur ne doit pas tenter générale d'installer ou de modifier le réglage.Lieu d'installationLe produit doit être installé à un endroit où l'antenne de rayonnement est maintenue à 20 cm de personnes à proximité dans son état defonctionnement normal, afin de répondre aux exigences réglementaires d'exposition aux radiofréquences.Antenne externeUtilisez uniquement l'antenne(s) qui ont été approuvés par le demandeur. Antenne (s) peuvent produire de l'énergie RF parasiteindésirable ou excessive transmission qui peut conduire à une violation des normes de la FCC / IC est interdite et non-approuvé.Procédure d'installationATTENTION: S'il vous plaît choisir avec soin la position d'installation et assurez-vous que la puissance de sortie final ne dépasse pas leslimites fixées dans les règles pertinentes. La violation de ces règles pourrait conduire à des sanctions fédérales graves.Federal Communication Commission interference statementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not causeharmful interference, and (2) this device must accept any interference received, including interference that may cause undesiredoperation.This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.FCC caution:• Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority tooperate this equipment.• This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Radiation exposure statement:12