Dell Edge Gateway 3003 Installation And Operation Manual

Also see for Edge Gateway 3001: Getting started guide Getting started guide Getting started guide Installation and operation manual

Contents

Dell Edge Gateway 3003 Installation And Operation Manual Manual pdf 13 page image

This equipment complies with FCC radiation exposure limits for an uncontrolled environment. This equipment should be installed andoperated with a minimum distance of 20 cm between the active transceiver and your body.NOTE: The country code selection is for a non-US model only and is not available to all US model. Per FCC regulation, all WiFiproducts marketed in the US must be fixed to US operation channels only.Industry Canada statementThis device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:1. this device may not cause interference, and2. this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation estautorisée aux deux conditions suivantes:1. l'appareil ne doit pas produire de brouillage, et2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettrele fonctionnement.Under Industry Canada regulations, the radio transmitter(s) may only operate using an antenna(s) of a type and maximum (or lesser) gainapproved for the transmitter(s). To reduce potential radio interference to other users, the antenna type(s) and gain(s) should be chosen sothat the Equivalent Isotropic Radiated Power (E.I.R.P.) is not more than what was approved for the transmitter(s).This Class A digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.This device complies with RSS-210 of Industry Canada. Operation is subject to the condition that this device does not cause harmfulinterference.Cet appareil est conforme à la norme RSS-210 d'Industrie Canada. L'opération est soumise à la condition que cet appareil ne provoqueaucune interférence nuisible.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, except testedbuilt-in radios.Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre antenne ou un autre émetteur,exception faites des radios intégrées qui ont été testées.The County Code Selection feature is disabled for products marketed in the US/Canada.La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux États-Unis et au Canada.Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Thisequipment should be installed and operated with minimum distance of 20 cm between the active transceiver and your body.Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour unenvironnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source derayonnement et votre corps.Setting up your Edge GatewayNOTE: Edge Gateway mounting options are sold separately.NOTE: Mounting can be done before or after configuring your Edge Gateway. For more information about mounting your EdgeGateway, see Mounting your Edge Gateway.NOTE: In some environments where the Edge Gateway may be installed, a more robust mounting method is required. For example,for mounting in marine applications, it is recommended to use only the standard— mount bracket. The recommendation is due to thepresence of vibrations unique to the marine environment.1. Use USB cables to connect a display, keyboard, and mouse.13