Dell Edge Gateway 3003 Installation And Operation Manual

Also see for Edge Gateway 3001: Getting started guide Getting started guide Getting started guide Installation and operation manual

Contents

Dell Edge Gateway 3003 Installation And Operation Manual Manual pdf 47 page image

5Setting up the operating systemCAUTION: To prevent operating system corruption from sudden power loss, use the operating system to gracefully shut down theEdge Gateway.The Edge Gateway is shipped with one of the following operating systems:• Windows 10 IoT Enterprise LTSB 2016• Ubuntu Core 16NOTE: For more information about Windows 10 operating system, see msdn.microsoft.com.NOTE: For more information about the Ubuntu Core 16 operating system, see www.ubuntu.com/desktop/snappy.Windows 10 IoT Enterprise LTSB 2016Boot up and login – Direct system configuration1. Connect a monitor, keyboard and mouse to the Edge Gateway before you login.2. Power on the Edge Gateway. At the first boot, you will not be prompted to enter login credentials. Subsequent boots will prompt foryou to log in.NOTE: The default user name and password are both admin.Boot up and login—Static IP system configurationNOTE: To help set up the Edge Gateway remotely, the static IP address of Ethernet port two on the Edge Gateway is set to thesevalues at the factory:• IP address: 192.168.2.1• Subnet mask: 255.255.255.0• DHCP server: Not applicableYou can connect your Edge Gateway to a Windows computer that is on the same subnet using a crossover cable.1. On the Windows computer, search for View network connections in the control panel.2. In the list of network devices displayed, right-click the Ethernet adaptor that you want to use to connect to the Edge Gateway, thenclick Properties.3. On the Networking tab, click Internet Protocol Version 4 (TCP/IPv4) → Properties.4. Select Use the following IP address, then enter 192.168.2.x (where x represents the last digit of the IP address, for example,192.168.2.2).NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between 192.168.2.2 to192.168.2.254.5. Enter the subnet mask 255.255.255.0 , then click OK.6. Secure a crossover network cable between Ethernet port two on the Edge Gateway and the configured Ethernet port on thecomputer.7. On the Windows computer, launch Remote Desktop Connection.8. Connect to the Edge Gateway using the IP address 192.168.2.1. The default username and password are both admin.47