Dell Force10 S2410-01-10GE-24P Quick Start Manual

Also see for Force10 S2410: Manual

Contents

18 Installing the SoftwareNOTE: Creating a management IP address is supported by both the Layer 2(Switching) and Layer 3 (Routing) licenses of SFTOS.By default, the management address is reachable from all ports on the defaultVLAN, VLAN 1. One or more ports in that VLAN must be enabled.After you enable and connect ports in the management VLAN and configure themanagement IP address, you can manage the switch through a variety of means.Configure a Username and PasswordThe username passwd command creates the username and password in onestatement. You can change a password either by reentering the command withthe new password or by removing the user with the no username command andreentering the user with a new password.Configure the Enable PasswordThe Privileged Exec password (commonly called the “enable” password), is notset when the S2410 starts for the first time. To set the enable password, accessthe Privileged Exec mode (also called “enable mode”) and then the GlobalConfig mode. Enter the enable passwd command, then press Enter.3 Invoke the (Config-if-ma)#prompt.interfacemanagementethernetGlobal Config4 Set the IP address and subnetmask of the managementinterface.ip address ipaddrsubnetmask(Config-if-ma)#prompt within theGlobal ConfigmodeStep Task Command Syntax Command Mode1 Configure a username andpassword.username passwd Config2 Removing a username. no username ConfigStep Task Command Syntax Command Mode