Dell Inspiron Zino HD 410 Service Manual

Back to Contents PageI/O BezelDell™ Inspiron™ 410 Service ManualRemoving the I/O BezelReplacing the I/O BezelRemoving the I/O Bezel1. Follow the procedures in Before You Begin.2. Remove the top cover (see Removing the Top Cover).3. Remove the bottom cover (see Removing the Bottom Cover).4. Press to release the tabs on the bottom of the I/O bezel from the slots on the chassis and lift the I/O bezel out of the computer.Replacing the I/O Bezel1. Follow the procedures in Before You Begin.2. Align the tabs on the I/O bezel with the slots on the computer and snap the I/O bezel into place.3. Replace the bottom cover (see Replacing the Bottom Cover).4. Replace the top cover (see Replacing the Top Cover).5. Connect your computer and all attached devices to electrical outlets, and turn them on.Back to Contents PageWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).1 tabs (3) 2 I/O bezelCAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.