Dell Inspiron Zino HD 410 Service Manual

Back to Contents PageOptical DriveDell™ Inspiron™ 410 Service ManualRemoving the Optical DriveReplacing the Optical DriveRemoving the Optical Drive1. Follow the procedures in Before You Begin.2. Remove the top cover (see Removing the Top Cover).3. Remove the top bracket (see Removing the Top Bracket).4. Disconnect the optical-drive cable from the connector on the optical drive.5. Push and slide the optical drive out through the front of the computer.Replacing the Optical Drive1. Follow the procedures in Before You Begin.2. Slide the optical drive into the drive bay.3. Connect the optical-drive cable to the connector on the optical drive.4. Replace the top bracket (see Replacing the Top Bracket).5. Replace the top cover (see Replacing the Top Cover).WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).1 optical-drive cable connector 2 drive bay3 optical driveCAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.