Dell Inspiron Zino HD 410 Service Manual

Back to Contents PageInfrared BoardDell™ Inspiron™ 410 Service ManualRemoving the Infrared BoardReplacing the Infrared BoardRemoving the Infrared Board1. Follow the procedures in Before You Begin.2. Remove the top cover (see Removing the Top Cover).3. Remove the top bracket (see Removing the Top Bracket).4. Remove the optical drive (see Removing the Optical Drive).5. Remove the drive bay (see Removing the Drive Bay).6. Disconnect the infrared cable from the infrared connector on the system board.7. Lift the release latch and remove the infrared board from the slot on the chassis.Replacing the Infrared Board1. Follow the procedures in Before You Begin.2. Replace the infrared board in the slot, and press it in, until it clicks into place.3. Connect the infrared cable to the infrared connector on the system board (see System Board Components).WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).1 infrared cable connector 2 release latch3 infrared board