Configuring iSCSI Optimization 421Configuring iSCSI Optimization (CLI)This section provides information about the commands you use to configureiSCSI settings on the PowerConnect M6348, M8024, or M8024-k switch. Formore information about the commands, see thePowerConnectM6220/M6348/M8024/M8024-k CLI Reference Guide atsupport.dell.com/manuals.Command Purposeconfigure Enter Global Configuration mode. iSCSIoptimization is enabled by default.iscsi target porttcp-port-1[tcp-port-2...tcp-port-16][addressip-address] [nametargetname]Configure an iSCSI target port and, optionally,address and name.•tcp-port-n—TCP port number or list of TCP portnumbers on which the iSCSI target listens torequests. Up to 16 TCP ports can be defined in thesystem in one command or by using multiplecommands.•ip-address—IP address of the iSCSI target. Whenthe no form of this command is used, and the tcpport to be deleted is one bound to a specific IPaddress, the address field must be present.•targetname—iSCSI name of the iSCSI target. Thename can be statically configured; however, it can beobtained from iSNS or from sendTargets response.The initiator must present both its iSCSI InitiatorName and the iSCSI Target Name to which it wishesto connect in the first login request of a new sessionor connection.
