Desktop Computer Parts 219NOTICE: To connect a network cable, first plug the cable into the network deviceand then plug it into the computer.8 Connect your computer and devices to electrical outlets, and turn themon.9 Right-click the My Computer icon and click Properties.10 Click the General tab.11 To verify that the memory is installed correctly, check the amount ofmemory (RAM) listed.Removing MemoryCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.NOTICE: Before removing memory, you may need to remove the Optical Drive. See"Optical Drive" on page 237.NOTICE: To prevent static damage to components inside your computer, dischargestatic electricity from your body before you touch any of your computer’s electroniccomponents. You can do so by touching an unpainted metal surface on thecomputer chassis.1 Follow the procedures in "Before You Begin" on page 143.2 Remove the computer cover (see "Removing the Computer Cover" onpage 209).3 Press out the securing clip at each end of the memory module connector.4 Grasp the module at the end of the board and lift up.5 Replace the Optical Drive, if necessary (see "Optical Drive" on page 237).6 Replace the computer cover.CardsCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.NOTICE: To prevent static damage to components inside your computer, dischargestatic electricity from your body before you touch any of your computer’s electroniccomponents. You can do so by touching an unpainted metal surface on thecomputer chassis.
