Dell OptiPlex 960 Service Manual

Also see for OptiPlex 960: Configuration guide Technical guidebook Setup and quick reference guide Setup and features information Technical specifications

Back to Contents PageDell™ Optiplex™ 960 Mini Tower/Desktop/Small Form Factor Service ManualI/O AssemblyI/O AssemblyRemoving the I/O Assembly1. Perform the procedure Before Working on Your Computer.2. Remove the bezel by releasing the three securing tabs and rolling it away from the top edge of the computer.3. Remove the optical drive (see Removing an Optical Drive).4. Disconnect the I/O assembly cables from the system board.5. Press the tab that secures the I/O assembly to the front panel, and gently move the I/O assembly away from the computer while guiding the I/Oassembly cables out of the chassis..CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.NOTE: Note the routing of all cables before disconnecting them, so that you can re route them correctly when installing the new I/O assembly.1 bezel 2 securing tabs (3)NOTICE: When sliding the I/O assembly out of the computer, be extremely careful. Carelessness may result in damage to the cable connectorsand the cable routing clips.