Dell Optiplex-620 User Manual

Also see for OptiPlex GX620: Specfications User guide Quick reference guide Quick reference guide Quick reference guide

Contents

Back to Contents PageBefore You BeginDell™ OptiPlex™ GX620User's GuideRecommended ToolsTurning Off Your ComputerBefore Working Inside Your ComputerThis chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that thefollowing conditions exist:l You have performed the steps in "Turning Off Your Computer" and "Before Working Inside Your Computer."l You have read the safety information in your Dell™ Product Information Guide.l A component can be replaced by performing the removal procedure in reverse order.Recommended ToolsThe procedures in this document may require the following tools:l Small flat-blade screwdriverl Phillips screwdriverl Flash BIOS update program floppy disk or CDTurning Off Your Computer1. Shut down the operating system:a. Save and close any open files, exit any open programs, click the Start button, and then click Turn Off Computer.b. In the Turn off computer window, click Turn off.The computer turns off after the operating system shutdown process finishes.2. Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shutdown your operating system, turn them off now.Before Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.1. Turn off your computer.2. Disconnect any telephone or telecommunication lines from the computer.3. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.NOTICE: To avoid losing data, save and close any open files and exit any open programs before you turn off your computer.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metalmounting bracket. Hold a component such as a processor by its edges, not by its pins.NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is notcovered by your warranty.NOTICE: When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. Some cables have a connector withlocking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keepthem evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented andaligned.NOTICE: To avoid damaging the computer, perform the following steps before you begin working inside the computer.NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.