Dell POWEREDGE 1950 Hardware Owner's Manual

Also see for PowerEdge 1950: Installation guide Installation information Installation guide Update Getting started

Contents

Dell POWEREDGE 1950 Hardware Owner's Manual Manual pdf 86 page image

86 Installing System ComponentsInstalling the Sideplane BoardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1 Align the guide on the end of the sideplane board with the pins on the system board, and lower thesideplane until that the sideplane connector is fully seated into the connector on the system board.2 Connect the control panel cable and optical drive cable (if applicable) to the sideplane. See Figure 6-8.3 Replace the SAS controller daughter card. See "Installing a SAS Controller Daughter Card or SAS RAIDController Daughter Card" on page 56.4 Close the system. See "Opening and Closing the System" on page 46.5 Replace the bezel. See "Removing and Replacing the Front Bezel" on page 45.6 Reconnect your system and peripherals to their electrical outlets, and turn on the system.System BatteryThe system battery is a 3.0-volt (V), coin-cell battery.Replacing the System BatteryCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.CAUTION: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery onlywith the same or equivalent type recommended by the manufacturer. Discard used batteries according to themanufacturer's instructions. See your System Information Guide for additional information.1 Turn off the system, including any attached peripherals, and disconnect the system from the electricaloutlet.2 Open the system. See "Opening and Closing the System" on page 46.3 If an expansion card is installed in the left riser board, remove the card. See "Removing an ExpansionCard" on page 62.4 Locate the battery socket. See Figure 3-24.NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board withthe object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out thebattery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on thesystem board.NOTICE: To avoid damage to the battery connector, you must firmly support the connector while installing orremoving a battery.