How can a SD card be recovered if the SD card was not in the chassis when the deactivation command was executedon the FlexAddress?The issue is that the SD card cannot be used to install FlexAddress on another chassis if it was not in CMC whenFlexAddress was deactivated. To recover use of the card, insert the card back into a CMC in the chassis that it is boundto, reinstall FlexAddress, and then deactivate FlexAddress, again.The SD card is properly installed and all the firmware/software updates are installed. The FlexAddress is active, theserver deployment screen does not display the options to deploy it? What is wrong?This is a browser caching issue. Shut down the browser and relaunch.What happens to FlexAddress if I need to reset my chassis configuration using the RACADM command,racresetcfg?The FlexAddress feature will still be activated and ready to use. All fabrics and slots are selected as default.NOTE: It is highly recommended that you power down your chassis before issuing the RACADM commandracresetcfg.After disabling only the FlexAddressPlus feature (leaving FlexAddress still activated), why does the racadmsetflexaddr command on the (stillactive) CMC fail?If the CMC subsequently becomes active, with the FlexAddressPlus feature card still in its cardslot, the FlexAddressPlusfeature gets re-activated, and slot or fabric flexaddress configuration changes can resume.iKVMThe message "User has been disabled by CMC control" appears on the monitor connected to the front panel. Why?The front panel connection has been disabled by CMC. Enable the front panel using either the CMC Web interface orRACADM.To enable the front panel using the CMC Web interface, go toiKVM → Setup tab, select the Front Panel USB/VideoEnabled option, and click Apply to save the setting.To enable the front panel using RACADM, open a serial/Telnet/SSH text console to CMC, log in, and type:racadm config -g cfgKVMInfo -o cfgKVMAccesToCMCEnable 1The rear panel access does not work. Why?The front panel setting is enabled by CMC, and a monitor is currently connected to the front panel.Only one connection is allowed at a time. The front panel connection has precedence over ACI and the rear panel. Formore information about connection precedence, see iKVM Connection Precedences.The message "User has been disabled as another appliance is currently tiered" appears on the monitor connected to therear panel. Why?A network cable is connected to the iKVM ACI port connector and to a secondary KVM appliance.Only one connection is allowed at a time. The ACI tiering connection has precedence over the rear panel monitorconnection. The precedence order is front panel, ACI, and then rear panel.The iKVM’s amber LED is blinking. Why?There are three possible causes:• There is problem with the iKVM, for which the iKVM requires reprogramming. To fix the problem, follow theinstructions for updating iKVM firmware.• The iKVM is reprogramming the CMC Console Interface. In this case, the CMC Console is temporarilyunavailable and represented by a yellow dot in the OSCAR interface. This process takes up to 15 minutes.• The iKVM firmware has detected a hardware error. For additional information, view the iKVM status.233
