136 Ethernet Configuration Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mshow ports jumbo-frameThe show ports jumbo-frame User EXEC mode command displays the jumbo framesconfiguration.Syntaxshow ports jumbo-frameDefault ConfigurationThis command has no default configuration.Command ModesUser EXEC modeUser Guidelines• There are no user guidelines for this command.Symbol Errors For an interface operating at 100 Mb/s, the number of times there was aninvalid data symbol when a valid carrier was present.For an interfaceoperating in half-duplex mode at 1000 Mb/s, the number of times thereceiving media is non-idle (a carrier event) for a period of time equal to orgreater than slotTime, and during which there was at least one occurrence ofan event that causes the PHY to indicate 'Data reception error' or 'carrierextend error' on the GMII.For an interface operating in full-duplex mode at1000 Mb/s, the number of times the receiving media is non-idle (a carrierevent) for a period of time equal to or greater than minFrameSize, and duringwhich there was at least one occurrence of an event that causes the PHY toindicate 'Data reception error' on the GMII.For an interface operating at 10Gb/s, the number of times the receiving media is non-idle (a carrier event) fora period of time equal to or greater than minFrameSize, and during whichthere was at least one occurrence of an event that causes the PHY to indicate'Receive Error' on the XGMII.Received Pause Frames Counted MAC Control frames received with an opcode indicating thePAUSE operation.Transmitted PauseFramesCounted MAC Control frames transmitted on this interface with an opcodeindicating the PAUSE operation.
