PowerConnect 5324 Release NotesSystem Firmware Version 2.0.0.39 Subject to Change Without Notice Page 6Documentation updatesIntroductionThis document lists the changes from the PowerConnect 5324 User’s Guide. The modifications are due to instancesdiscovered in various user environments.GeneralThe following must be changed globally:Starting and Configuring the DeviceAssigning Static IP Addresses on an Inband InterfaceModify the following:Current NewConsole (config-if) # ip address 192.168.1.123/24255.255.255.0Console (config-if) # ip address 192.168.1.123255.255.255.0Configuring an Initial HTTPS PasswordDelete the following:Enter the following commands once when configuring to use a terminal, a Telnet, or an SSH session in order to usean HTTPS session.Note: In the Web browser enable SSL 2.0 or greater for the page content to be displayed.console(config)# crypto certificate generate key_generateconsole(config)# ip https server Telnet ConnectionTo start communications using automatic baud detection, press the Enter key twice. The factory default is autobaudenabled and no synchronization between a terminal and a device is required during the initial device installation. If,during the operation, the terminal was replaced by another one or the speed mode was switched over on the device,the following must be taken into consideration:• A blank screen appearing after reset is an indication that the terminal and the device are not synchronized. Toactivate the autobaud option, press the Enter key twice.• If the autobaud option is enabled on the device, it automatically becomes operational after reset ONLY ONCE,after pressing the Enter key twice. Configuring Domain Name SystemsUnder the Add DNS page add the following field description:DNS Server — DNS Server Name. The name cannot start with a numeric character.