Dell PowerConnect 5324 Release Note

Also see for 5324 - PowerConnect Switch: User guide addendum Command line interface reference manual User guide

Dell PowerConnect 5324 Release Note Manual pdf 11 page image

PowerConnect 5324 Release NotesSystem Firmware Version 2.0.0.39 Subject to Change Without Notice Page 7 Defining a New CommunityAdd extra instructions.Current New5 Click Apply Changes.The new community is saved, and thedevice is updated.5 Click Apply Changes.6 Close Add SNMP Community page. The SNMPCommunity page is displayed.7 Click Refresh.The new community is inserted.Defining SNMP TrapsAdd extra instructions.Current New5 Click Apply Changes.SNMP traps are enabled on the card.5 Click Apply Changes.6 Click Refresh.SNMP traps are enabled on the card.LAG ConfigurationDefining LAG ParametersAdd to the description:The LACP port channel can accept up to 16 ports but only 8 will be active at the same time.Storm ControlAdd to description: Storm Control is enabled per Gigabit ports by defining the packet type and the rate the packetsare transmitted. Ports can also be grouped to provide Storm protection for the entire group.Modify the CLI CommandCurrent Newport storm-control broadcast enable port storm-control broadcast enable [ethernet interface]ModifyField Current NewBroadcast Rate Threshold (1-1000000)—The maximum rate (packets per second) atwhich unknown packets are forwarded. Therange is 0-1000000. The default value iszero. All values are rounded to the nearest64Kbps. If the field value is under 64Kbps,the value is rounded up to 64Kbps, with theexception of the value zero.Broadcast Rate Threshold (0-65535) — Themaximum rate (packets per second) atwhich unknown packets are forwarded. Therange is 0-65535. The default value is zero.All values are rounded to the nearest64Kbps. If the field value is under 64Kbps,the value is rounded up to 64Kbps, with theexception of the value zero. Note that if therate is 0, broadcast packets are notforwarded.