8. Place the SF module in the antistatic bag or on the antistatic mat.9. If you are not replacing the SF module, install the cover panel over the empty slot bytightening the screws on each side of the cover panel with the screwdriver.Figure 85: Removing an SF Module from a J-EX8208 SwitchRelatedDocumentationInstalling an SF Module in a J-EX8208 Switch on page 120•• Switch Fabric (SF) Module in a J-EX8208 Switch on page 25Removing a Line Card from a J-EX8200 SwitchJ-EX8200 switches have field-replaceable unit (FRU) line cards that can be installed inthe line card slots on the front of the switch chassis. The line cards are hot-insertableand hot-removable: You can remove and replace them without powering off the switchor disrupting switch functions.Before you begin removing a line card from a J-EX8200 switch:• Ensure that you have taken the necessary precautions to prevent ESD damage (see“Prevention of Electrostatic Discharge Damage on J-EX Series Switches” on page 236).• If there are any transceivers installed in the line card, remove them before you removethe line card. See “Removing a Transceiver from a J-EX Series Switch” on page 173.• Ensure that you know how to handle and store the line card (see “Handling and StoringLine Cards in J-EX8200 Switches” on page 179).Ensure that you have the following parts and tools available to remove a line card froma J-EX8200 switch chassis:170Dell PowerConnect J-Series J-EX8208 Ethernet Switch Hardware Guide
