Table 32 on page 92 describes alarms that can occur for a J-SRX100 Services Gatewaychassis component.Table 32: J-SRX100 Services Gateway Chassis Alarm Conditions andCorrective ActionsAlarmSeverityActionAlarm ConditionsComponentAmber(minor)• If the internal flash fails at startup,the services gateway automaticallyboots itself from the alternative bootdevice (USB storage device).NOTE: If you configured your servicesgateway to boot from an alternativeboot device, ignore this alarm condition.• Reformat the internal flash andinstall a bootable image. (See theJunos OS Administration Guide.)• If you did not configure the servicesgateway to boot from an alternativeboot device, contact Dell Support.See “Dell Support” on page 95.The services gatewayboots from an alternateboot device.Boot mediaAmber(minor)Check the room temperature. See“J-SRX100 Services GatewaySpecifications” on page 7.The services gatewaychassis temperature orchassis is too warmHardwarecomponentson theservicesgateway Red(major)The services gateway shuts downautomatically in four minutes.The services gatewaytemperature is too high,either because of aninternal overheatingcondition or because themaximum recommendedroom temperature hasbeen exceeded.RelatedDocumentationMonitoring the J-SRX100 Services Gateway Chassis Using the CLI on page 87•• Monitoring the J-SRX100 Services Gateway Components Using LEDs on page 89• Monitoring the J-SRX100 Services Gateway Power System on page 92• Using the Reset Config Button on the J-SRX100 Services Gateway on page 93• Changing the Reset Config Button Behavior on the J-SRX100 Services Gateway onpage 94• Dell Support on page 95Monitoring the J-SRX100 Services Gateway Power SystemThe LEDs on the services gateway enable you to determine the performance andoperation. The Power LED, located on the front panel of the services gateway, indicatesthe different settings with respect to the power system.92PowerConnect J-SRX100 Services Gateway Hardware Guide
