Dell PowerConnect W-7200 Series Reference Manual

Also see for PowerConnect W-7200 Series: Installation guide

Contents

Dell PowerConnect W-7200 Series Reference Manual Manual pdf 11 page image

l Thestartup config holds the configuration which will be used the next time the controller is rebooted. It containsall the options last saved using the write memory command. To view the startup-config, use the followingcommand:(host) # show startup-configWhen you make configuration changes via the CLI, those changes affect the current running configuration only. Ifthe changes are not saved, they will be lost after the controller reboots. To save your configuration changes so theyare retained in the startup configuration after the controller reboots, use the following command in enable mode:(host) # write memorySaving Configuration...Saved ConfigurationBoth the startup and running configurations can also be saved to a file or sent to a TFTP server for backup ortransfer to another system.Commands That Reset the Controller or APIf you use the CLI to modify a currently provisioned and running radio profile, those changes take placeimmediately; you do not reboot the controller or the AP for the changes to affect the current running configuration.Certain commands, however, automatically force the controller or AP to reboot. You may want to consider currentnetwork loads and conditions before issuing these commands, as they may cause a momentary disruption in serviceas the unit resets. Note also that changing the lms-ip parameter in an AP system profile associated with an AP groupwill cause all APs in that AP group to reboot.Commands that Reset an AP Commands that Reset a Controllerl ap-regroupl ap-renamel apbootl provision-apl ap wired-ap-profile forward-mode {bridge|split-tunnel|tunnel}l wlan virtual-ap {aaa-profile |forward-mode {tunnel|bridge|split-tunnel|decrypt-tunnel} |ssid-profile |vlan ...}l ap system-profile {bootstrap-threshold |lms-ip |}l wlan ssid-profile {battery-boost|deny-bcast|essid|opmode|strict-svp |wepkey1 |wepkey2|wepkey3 |wepkey4 |weptxkey |wmm|wmm-be-dscp |wmm-bk-dscp |wmm-ts-min-inact-int |wmm-vi-dscp

|wpa-hexkey |wpa-passphrase }l wlan dotllk {bcn-measurement-mode|dot11k-enable|force-dissasocl reloadTable 1:Reset CommandsTypographic ConventionsThe following conventions are used throughout this manual to emphasize important concepts:Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide Introduction | 11