Dell PowerEdge 2900 Manual
Also see for PowerEdge 2900: Getting startedInstallation informationInstallation guideInstallation guideUpdate
                          | |
Contents
| 
Tower-to-Rack Conversion Guide 15Removing the Tower Front PlateUsing a T-10 Torx driver, remove the 29 screws that secure the tower front plate to the system chassis. SeeFigure 1-5.Figure 1-5. Removing the Tower Front PlateInstalling the Rack Front Plate1 Using a T-10 Torx driver, install the 34 screws (that came in your kit) to secure the rack front panel tothe system chassis. See Figure 1-6.NOTICE: Do not over-tighten the screws.2 Attach the rack ear pieces to the system chassis.a Align the flanges of the right rack ear piece against the right side of the system chassis with theupper flange of the piece inserted between the double walls on the chassis. See Figure 1-6.b Align the flanges with the screw holes and secure the ear piece with four 6-32 flathead Phillipsscrews. See Figure 1-6.NOTICE: Do not over-tighten the screws.c Repeat for the left rack ear piece.1 tower front plate 2 M3 x 8 T10 Torx flathead screw(29)12book.book Page 15 Friday, May 26, 2006 3:03 PM |
Related manuals for Dell PowerEdge 2900
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine