18 Using the Baseboard Management Controllerw w w . d e l l . c o m | s u p p o r t . d e l l . c o mNetwork ConfigurationNOTE: To change any of the settings on the Network Configuration page, you must have permission toconfigure iBMC.NOTE: The Dell Remote Management Controller is fully IPMI 2.0 compliant. You can configure the DellRemote Management Controller IPMI using your browser or by using an open source utility, such asipmitool.Table 1-17. Common SettingsSettings DescriptionRegister iBMC on DNS When checked, register this address with the Domain Name Server(DNS).DNS iBMC Name Name to use when registering with DNS.Use DHCP for DNS DomainNameEnable / disable acquisition of DNS from DHCP.DNS Domain Name Domain name to be used if it was not acquired from DHCP.Table 1-18. IPv4 SettingsSettings DescriptionIPv4 Enabled If NIC enabled, this selects IPv4 protocol support, and the other fieldsin this section to be enabled.DHCP Enabled Enable / disable using DHCP for this function.IP Address Use this IP address.Gateway Setup the gateway of the iBMC.Subnet Mask Subnet maskUse DHCP to obtain DNS serveraddressesEnable / disable using DHCP for this function.Preferred DNS Server Specify the IP address of the preferred DNS server.Alternate DNS Server Specify the alternative IP address to be used when the preferred DNSserver is not available.