Running the System Diagnostics 173Using the Custom Test OptionsWhen you select Custom Test in the Main Menu window, the Customizewindow allows you to select the device(s) to be tested, select specific optionsfor testing, and view the test results.Selecting Devices for TestingThe left side of the Customize window lists devices that can be tested. Clickthe (+) next to a device or module to view its components. Click (+) on anycomponent to view the tests that are available. Clicking a device, rather thanits components, selects all of the components of the device for testing.NOTE: After you select all the devices and components that you want to test,highlight All Devices and then click Run Tests.Selecting Diagnostics OptionsFrom the Diagnostics Options area, select the test(s) you want to run on adevice.• Non-Interactive Tests Only — Runs only tests that require no userintervention.• Quick Tests Only — Runs only the quick tests on the device.• Show Ending Timestamp — Time stamps the test log.• Test Iterations — Selects the number of times the test is run.• Log output file pathname — Enables you to specify the diskette drive orUSB memory key where the test log file is saved. You cannot save the file toa hard drive.Viewing Information and ResultsThe following tabs in the Customize window provide information about thetest and the test results.• Results — Displays the test that ran and the result.• Errors — Displays any errors that occurred during the test.• Help — Displays information about the currently selected device,component, or test.