Using the System Setup Program and UEFI Boot Manager 59SATA Settings ScreenBoot Settings ScreenOption DescriptionEmbedded SATA(Off default)ATA Mode enables the integrated SATA controller. Offdisables the controller.Port A(Off default)Auto enables BIOS support for the device attached toSATA port A. Off disables BIOS support for the device.Option DescriptionBoot Mode(BIOS default)CAUTION: Switching the boot mode could preventthe system from booting if the operating system wasnot installed in the same boot mode.If the operating system supports Unified ExtensibleFirmware Interface, you can set this option to UEFI.Setting this field to BIOS allows compatibility with non-UEFI operating systems.NOTE: Setting this field to UEFI disables the BootSequence, Hard-Disk Drive Sequence, and USB Flash DriveEmulation Type fields.Boot Sequence If Boot Mode is set to BIOS, this field tells the systemwhere the operating system files needed for startup arelocated. If Boot Mode is set to UEFI, you can access theUEFI boot manager utility by rebooting the system andpressing when prompted to do so.Hard-Disk DriveSequenceDetermines the order in which the BIOS attempts toboot from hard drives in the system during systemstartup.USB Flash DriveEmulation TypeDetermines the emulation type for a USB flash drive. IfBoot Mode is set to UEFI, this field is disabled.Boot Sequence Retry(Disabled default)If this field is enabled and the system has failed to boot,the system reattempts to boot after 30 seconds.