72 Using the System Setup Program and UEFI Boot ManagerSerial Communication ScreenOption DescriptionSerial Communication(On without ConsoleRedirection default)Selects whether the serial communication devices(Serial Device 1 and Serial Device 2) are enabled inBIOS. BIOS console redirection can also be enabled andthe port address used can be specified.Options are On without Console Redirection, On withConsole Redirection via COM1, On with ConsoleRedirection via COM2, and Off.Serial Port Address(Serial Device 1=COM1,Serial Device2=COM2default)Sets the serial port addresses for the two serial devices.NOTE: Only Serial Device 2 can be used for Serial OverLAN (SOL). To use console redirection by SOL, configurethe same port address for console redirection and theserial device.External Serial Connector Specifies whether Serial Device 1, Serial Device 2, orRemote Access Device has access to the external serialconnector.NOTE: Only Serial Device 2 can be used for Serial OverLAN (SOL). To use console redirection by SOL, configurethe same port address for console redirection and theserial device.Failsafe Baud Rate(115200 default)Displays the failsafe baud rate used for consoleredirection. BIOS attempts to determine the baud rateautomatically. This failsafe baud rate is used only if theattempt fails. This rate should not be adjusted.Remote Terminal Type(VT 100/VT220 default)Sets the remote console terminal type, eitherVT100/VT220 or ANSI.Redirection After Boot(Enabled default)Enables or disables BIOS console redirection when theoperating system is loaded.
