PE RC 3/ QC Har d war e Ins ta l lati on 147Firmware Initializing... [Scanning SCSI Device...(etc.)...]The firmware takes several seconds to initialize. During this time theadapter will scan the SCSI channel. When ready, the following appears:HA –0 (Bus 1 Dev 6) Type: PERC 3/QC Standard FW x.xx SDRAM=xxxMBBattery Module is Present on Adapter0 Logical Drives found on the Host Adapter0 Logical Drive(s) handled by BIOSPress to run PERC 3 BIOS Configuration UtilityOr press to run WebBIOSThe BIOS Configuration Utility prompt times out after several seconds.The PERC 3/QC host adapter (controller) number, firmware version, andcache SDRAM size are displayed in the second portion of the BIOSmessage. The numbering of the controllers follows the PCI slot scanningorder used by the host motherboard.Step 9—Run the PERC 3 BIOS Configuration Utility orWebBIOS Configuration UtilityPress to run the PERC 3 BIOS Configuration Utility or to run the WebBIOS Configuration Utility. See Chapter 11"PERC 3 BIOS Configuration Utility" for additional information aboutrunning the PERC 3 BIOS Configuration Utility. WebBIOS is an HTML-based configuration utility. See the WebBIOS Configuration Utility Guidefor additional information about running WebBIOS.Step 10—Install Operating System DriverSee the PERC 3 Operating System Driver Installation Guide for additionalinformation about installing the drivers for Windows NT® , Windows ®2000, Novell ® NetWare® , and Red Hat Linux.
