Installing a hard-drive/SSD blankPrerequisites1. Ensure that you read the Safety instructions.2. Remove a hard drive/SSD. See Removing a hard drive/SSD.StepsInsert the hard-drive/SSD blank into the hard-drive/SSD slot until the release latch clicks into place.Shutdown procedure for servicing a hard drive/SSDNOTE: This section applies only to situations where the blade must be powered down to service ahard drive/SSD. In many situations, the hard drive/SSD can be serviced while the blade is poweredon.CAUTION: If you need to power off the blade to service a hard drive/SSD, wait 30 seconds afterthe blade’s power indicator turns off before removing the hard drive/SSD. Otherwise, the harddrive/SSD may not be recognized after it is reinstalled and the blade is powered on again.Configuring the boot driveThe drive or device from which the system boots is determined by the boot order specified in the SystemSetup.Removing a 2.5 inch hard drive/SSD from a 2.5 inch hard-drive/SSD carrierPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.1. Ensure that you read the Safety instructions.2. Keep the #1 Phillips screwdriver ready.Steps1. Remove the four screws from the slide rails on the hard-drive/SSD carrier.2. Slide the hard drive/SSD out of the hard-drive/SSD carrier.76
