4Installing and removing server modulecomponentsThis section provides information on installing and removing the server module components. Forinformation on installing and removing the enclosure components, see the enclosure Owner's Manual atdell.com/poweredgemanuals.Safety instructionsCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: It is recommended that you always use a static mat and static strap while working oncomponents inside the system.NOTE: To ensure proper operation and cooling, all bays in the system must be populated at alltimes with either a system component or with a blank.Before working inside your system1. Turn off the server module using the CMC.2. Remove the server module from the enclosure.3. Install the I/O connector cover.4. Remove the system cover. See Removing the system cover.After working inside your system1. Install the system cover. See Installing the system cover.2. Install the server module in the enclosure.3. Turn on the server module.Recommended toolsYou may need the following items to perform the procedures in this section:• #1 and #2 Phillips screwdrivers• T8 and T10 Torx drivers• Wrist grounding strap• Hex nut driver-5 mm36
