a. hard-drive/SSD cageb. hard-drive/SSD backplanec. hard drives/SSDs3. Follow the procedure listed in After working inside your system.Related LinksRemoving a hard drive/SSDRemoving the hard-drive/SSD backplaneRemoving the hard-drive/SSD cageInstalling the PCIe extender/storage controller cardPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.NOTE: PCIe extender/storage controller card is supported on systems with the SAS backplanes.NOTE: You must remove the PCIe extender/storage controller card to replace a faulty PCIeextender/storage controller card or service other components inside the system.1. Ensure that you read the Safety instructions.2. Keep the #2 Phillips screwdriver ready.3. Remove the PCIe extender/storage controller card. See Removing the PCIe extender/storagecontroller card.Steps1. Align the slots on the PCIe extender/storage controller card edge with the tabs on the supportbracket.CAUTION: To prevent damage to the PCIe extender/storage controller card, you must holdthe card only by its edges.2. Lower the PCIe extender/storage controller card on to the connector on the system board.3. Tighten the two retention screws on the hard-drive/SSD backplane cable connector to secure thecard on to the system board.Next steps1. Install the following:a. hard drives/SSDsb. hard-drive/SSD backplanec. hard-drive/SSD cage2. Follow the procedure listed in After working inside your system.Related LinksInstalling a hard drive/SSDInstalling the hard-drive/SSD backplane87
