Dell PowerEdge R410 Hardware Owner's Manual

Also see for PowerEdge R410: Update Technical guide Portfolio guide Manual Information update

Contents

Dell PowerEdge R410 Hardware Owner's Manual Manual pdf 114 page image

114 Installing System ComponentsReplacing a Cooling Fan1 Ensure that the fan is oriented correctly.Orient the fan module so that the side with the power cable faces towardsthe back of the system.2 Slide the fan module into the fan assembly until the fan is fully seated. SeeFigure 3-18.3 Connect the fan’s power cable to the power connector on the systemboard.4 Replace the system board shroud. See "Installing the System BoardShroud" on page 106.5 Close the system. See "Closing the System" on page 83.6 Reconnect the system to its electrical outlet and turn the system on,including any attached peripherals.Optical DriveAn optional slimline DVD or DVD-RW optical drive slides into the front paneland connects to the SATA controller on the system board.NOTE: DVD devices are data only.Removing an Optical DriveWARNING: Only trained service technicians are authorized to remove the systemcover and access any of the components inside the system. Before you begin thisprocedure, review the safety instructions that came with the system.1 If installed, remove the optional front bezel. See "Removing and Replacingthe Optional Front Bezel" on page 81.2 Turn off the system, including any attached peripherals, and disconnectthe system from its electrical outlet.