About Your System 23LCD Status Messages (Optional)The system's control panel LCD provides status messages to signify when thesystem is operating correctly or when the system needs attention.The LCD lights blue to indicate a normal operating condition, and lightsamber to indicate an error condition. The LCD scrolls a message thatincludes a status code followed by descriptive text. The table that followsprovides a listing of LCD status messages and the probable cause for eachmessage. The LCD messages refer to events recorded in the System EventLog (SEL). For information on the SEL and configuring system managementsettings, see the systems management software documentation.NOTE: If your system fails to boot, press the System ID button for at least fiveseconds until an error code appears on the LCD. Record the code, then see "GettingHelp" on page 167.Table 1-2. LCD Status Messages (Optional)Code Text Causes Corrective ActionsN/A SYSTEM NAME A 62-character string thatcan be defined by the userin the System Setupprogram.TheSYSTEM NAMEdisplays under thefollowing conditions:• The system ispowered on.• The power is off andactive errors aredisplayed.This message is forinformation only.You can change thesystem ID and name inthe System Setupprogram. See "Using theSystem Setup Programand UEFI Boot Manager"on page 57.E1000 Failsafevoltage error.Contactsupport.Check the system eventlog for critical failureevents.Remove AC power to thesystem for 10 seconds andrestart the system.If the problem persists,see "Getting Help" onpage 167.
