CAUTION: To prevent data loss, ensure that your operating system supports hot-swap driveinstallation. See the documentation supplied with your operating system.CAUTION: When a replacement hot-swappable hard drive is installed and the system is poweredon, the hard drive automatically begins to rebuild. Make absolutely sure that the replacementhard drive is blank or contains data that you wish to have over-written. Any data on thereplacement hard drive is immediately lost after the hard drive is installed.Steps1. If a hard-drive blank is installed in the hard-drive slot, remove it.2. Install a hard drive in the hard-drive carrier.3. Press the release button on the front of the hard-drive carrier and open the hard-drive carrier handle.4. Insert the hard-drive carrier into the hard-drive slot until the carrier connects with the backplane.5. Close the hard-drive carrier handle to lock the hard drive in place.Removing a hard drive from a hard-drive carrierPrerequisites1. Keep the #1 Phillips screwdriver handy.2. Remove the hard-drive carrier from the system.Steps1. Remove the screws from the slide rails on the hard-drive carrier.2. Lift the hard drive out of the hard-drive carrier.Figure 70. Removing and installing a hard drive into a hard-drive carrier1. screw (4) 2. hard drive3. hard-drive carrierRelated videohttp://www.Dell.com/QRL/Server/PER730/HDD143
