92 Configuring and Managing RAID3 Press to display the menu of available actions.4 Press the down-arrow key to select Consistency Check.5 Press the right-arrow key to display the available actions (Start, Stop).6 Select Start and press to run a Consistency Check.The Consistency Check runs and checks the redundancy data in thevirtual disks.7 After you start the Consistency Check, press to display theprevious menu if needed.Importing or Clearing Foreign Configurations Using the VD Mgmt MenuWhen a foreign configuration exists, the BIOS screen displays the messageForeign configuration(s) found on adapter. In addition,a foreign configuration is displayed on the right side of the Ctrl Mgmt screen.You can use the VD Mgmt menu to import the existing configuration to theRAID controller or clear the existing configuration. In addition, you can viewthe foreign configuration from the Foreign View tab without importing theconfiguration.NOTE: The controller does not allow an import of configurations that results inmore than 64 virtual disks.NOTE: To import a secured foreign configuration, see "Security Key and RAIDManagement" on page 121.Perform the following steps to import or clear foreign configurations:1 During bootup, press when prompted by the BIOS screen.The VD Mgmt screen is displayed by default.2 On the VD Mgmt screen, highlight the Controller #.3 Press to display the available actions.
