Installing System Components 1033 Locate the USB connector on the internal USB module and insert theUSB memory key into the connector. See Figure 3-12.4 Close the system. See "Closing the System."5 Place the system upright and on its feet on a flat, stable surface.6 Reattach any peripherals, then connect the system to the electrical outlet.7 Turn on the system and attached peripherals.Integrated Dell Remote Access Controller 6(iDRAC6) Enterprise Card (Optional)The optional iDRAC6 Enterprise card provides a set of advanced features formanaging the system remotely.Installing the iDRAC6 Enterprise Card1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet and peripherals.2 Open the system. See "Opening the System."3 Remove the expansion card stabilizer. See "Removing the Expansion CardStabilizer."4 Remove the cooling shroud. See "Removing the Cooling Shroud."5 Remove the plastic filler plug for the iDRAC6 Enterprise port from thesystem back panel. See "Back-Panel Features and Indicators" for the portlocation.6 Remove the VFlash SD card (if installed) from the iDRAC6 Enterprisecard. See "VFlash Media (Optional)."7 Install the iDRAC6 Enterprise card:a Angle the card so that the RJ-45 connector fits through the hole in thechassis for the iDRAC6 Enterprise port. See Figure 1-4 for the holelocation.b Align the front edge of the card with the two front plastic retentionstandoffs near the iDRAC6 connector on the system board. SeeFigure 6-1 for the location of the connector.c Press the card down until it is fully seated. See Figure 3-13.
