Option DescriptionExternal SerialConnectorEnables you to associate the External Serial Connector to Serial Device 1, SerialDevice 2, or the Remote Access Device by using this option.NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To useconsole redirection by SOL, configure the same port address for consoleredirection and the serial device.NOTE: Every time the system boots, the BIOS syncs the serial MUX settingsaved in iDRAC. The serial MUX setting can independently be changed iniDRAC. Loading the BIOS default settings from within the BIOS setup utilitymay not always revert this setting to the default setting of Serial Device 1.Failsafe Baud Rate Specifies the failsafe baud rate for console redirection. The BIOS attempts todetermine the baud rate automatically. This failsafe baud rate is used only if theattempt fails, and the value must not be changed. This option is set to 115200 bydefault.Remote TerminalTypeSets the remote console terminal type. This option is set to VT 100/VT 220 bydefault.Redirection AfterBootEnables or disables the BIOS console redirection when the operating system isloaded. This option is set to Enabled by default.Related LinksSerial CommunicationViewing Serial CommunicationSystem Profile SettingsYou can use the System Profile Settings screen to enable specific system performance settings such aspower management.Related LinksSystem Profile Settings detailsSystem BIOSViewing System Profile SettingsViewing System Profile SettingsTo view the System Profile Settings screen, perform the following steps:1. Turn on, or restart your system.2. Press F2 immediately after you see the following message:F2 = System SetupNOTE: If your operating system begins to load before you press F2, wait for the system to finishbooting, and then restart your system and try again.3. On the System Setup Main Menu screen, click System BIOS.4. On the System BIOS screen, click System Profile Settings.Related LinksSystem Profile SettingsSystem Profile Settings detailsSystem Profile Settings detailsThe System Profile Settings screen details are explained as follows:67
