Item Indicator, Button, orConnector Icon DescriptionUse this button only if directed to do so by qualifiedsupport personnel or by the operating system'sdocumentation.5 Hard drives Up to twelve 3.5 inch hot-swappable hard drives.6 Video connector Allows you to connect a VGA display to the system.7 USB connector Allows you to connect USB devices to the system. Theport is USB 2.0-compliant.8 Information tag A slide-out label panel which allows you to record systeminformation such as Service Tag, NIC, MAC address, andso on as per your need.Diagnostic IndicatorsThe diagnostic indicators on the system front panel display error status during system startup.NOTE: No diagnostic indicators are lit when the system is switched off. To start the system, plug it into a workingpower source and press the power button.The following section describes system conditions and possible corrective actions associated with these indicators:Health indicatorCondition Corrective ActionIf the system is on,and in good health,the indicator lightssolid blue.None required.The indicator blinksamber if the systemis on or in standby,and any error exists(for example, a failedfan or hard drive)See the System Event Log or system messages for the specific issue.Invalid memory configurations can cause the system to halt atstartup without any video output. See Getting Help.Hard-drive indicatorCondition Corrective ActionThe indicator blinksamber if a hard driveexperiences anerror.See the System Event Log to determine the hard drive that has anerror. Run the appropriate Online Diagnostics test. Restart systemand run embedded diagnostics (ePSA). If the hard drives areconfigured in a RAID array, restart the system and enter the hostadapter configuration utility program.10
