Figure 35. Removing and Installing the Network Daughter Card1. captive screw sockets (2)2. connector on the system board3. captive screws (2)4. touch point5. network daughter card6. back panel slot for RJ-45 connectorsInstalling The Network Daughter CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Angle the card so that the RJ-45 connectors fit through the slot in the back panel.2. Align the captive screws at back-end of the card with the captive screw sockets on the system board.3. Press the touch point on the card until the card connector is firmly seated on the system board connector.4. Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card to the systemboard.5. If applicable, install the expansion card(s) in the expansion-card riser 2.6. Close the system.7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.ProcessorsUse the following procedure when:• Installing an additional processor• Replacing a processor64
