hard drives and also enables you to set up the hard drives in RAID configurations as supported by the version of thestorage controller included with your system.Removing The Integrated Storage Controller CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Remove the cooling shroud.4. Remove the expansion-card riser 1.5. Push down the two release levers at the edge of the card to disengage the card from the connector.6. Angle the card so that the other end of the card disengages from the storage-controller card holder on the systemboard.7. Replace the expansion-card riser 1.8. Replace the cooling shroud.9. Close the system.10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Figure 34. Removing and Installing the Integrated Storage Controller Card1. storage connector on the system board2. storage controller card62
