Troubleshooting: Your Storage Array Software 2411 On the Logical tab of the AMW, select one of these virtual disks, and go tothe indicated step:• Snapshot virtual disk—Go to step 2.• Snapshot repository virtual disk—Go to step 3.• Source virtual disk—Go to step 4.• Target virtual disk—Go to step 5.2 Select View Go To Snapshot Virtual Disk.The selection jumps to the associated snapshot virtual disk in the Logicalpane.3 Select View Go To Snapshot Repository Virtual Disk.The selection jumps to the associated snapshot repository virtual disk inthe Logical pane.4 Select View Go To Source Virtual Disk.The selection jumps to the associated source virtual disk in the Logicalpane.5 Select View Go To Target Virtual Disk.NOTE: If the source virtual disk has more than one associated target virtualdisk, select the target virtual disk that you want from the list, and click OK.The selection jumps to the associated target virtual disk in the Logical pane.Recovering From an Unresponsive Storage ArrayConditionA storage array can have an Unresponsive status for several reasons. Use theprocedure in this topic to determine a possible cause and solution.MDSM can take up to 5 minutes to detect that a storage array has becomeunresponsive or becomes responsive again. Before completing this procedure,make sure that you wait some time before you decide that the storage array isstill unresponsive.
