Configuration: About Your Storage Array 69• Save Configuration—Save the configuration parameters in a file that youcan use to restore the configuration, or reuse the configuration on anotherstorage array. For more information, see the PowerVault Modular DiskStorage Manager online help topics.After you complete the basic steps for configuring the storage array, you canperform these optional tasks:• Manually define hosts—Define the hosts and the host port identifiers thatare connected to the storage array. Use this option only if the host is notautomatically recognized and shown in the Mappings tab.• Configure ethernet management ports—Configure the networkparameters for the Ethernet management ports on the RAID controllermodules if you are managing the storage array by using the out-of-bandmanagement connections.• View and enable premium features—Your MDSM may include premiumfeatures. View the premium features that are available and the premiumfeatures that are already started. You can start available premium featuresthat are currently stopped.Locating Storage ArraysYou can use the Blink option to physically locate and identify a storage array.NOTE: If the LEDs from the Blink Storage Array operation do not stop blinking,select Stop All Indications to stop the process manually.To locate the storage array:1 Select the relevant storage array and:• In the EMW, right-click the appropriate storage array, and select BlinkStorage Array.• In the AMW, select the Setup tab, click Blink Storage Array.• In the AMW, select Storage ArrayBlinkStorage Array.The LEDs blink on the physical disks in the storage array.2 After locating the storage array, click OK.The LEDs stop blinking.3 If the LEDs do not stop blinking, select Storage ArrayBlink Stop AllIndications.
